South African Class FC 2-6-2+2-6-2

South African Class FC 2-6-2+2-6-2

Class FC no. 2310, later renumbered 670, c. 1925
Type and origin
Power type Steam
Designer North British Locomotive Company
Builder North British Locomotive Company
Serial number 23140
Model Class FC
Build date 1924
Total produced 1
Specifications
Configuration 2-6-2+2-6-2 (Double Prairie)
Driver 3rd & 4th coupled axles
Gauge 3 ft 6 in (1,067 mm) Cape gauge
Leading dia. 28 12 in (724 mm)
Coupled dia. 42 34 in (1,086 mm)
Trailing dia. 28 12 in (724 mm)
Wheelbase 56 ft 8 in (17,272 mm)
  Engine 17 ft 8 14 in (5,391 mm) each
  Coupled 8 ft (2,438 mm) each
Pivot centres 35 ft 8 in (10,871 mm)
Length:
  Over couplers 63 ft 9 in (19,431 mm)
Height 12 ft 3 in (3,734 mm)
Frame type Plate
Axle load 10 LT 10 cwt (10,670 kg)
  Leading 9 LT 11 cwt (9,703 kg) front
9 LT 2 cwt (9,246 kg) rear
  1st coupled 10 LT 10 cwt (10,670 kg)
  2nd coupled 10 LT 10 cwt (10,670 kg)
  3rd coupled 10 LT 10 cwt (10,670 kg)
  4th coupled 10 LT 10 cwt (10,670 kg)
  5th coupled 10 LT 8 cwt (10,570 kg)
  6th coupled 10 LT 10 cwt (10,670 kg)
  Trailing 9 LT 4 cwt (9,348 kg) front
8 LT 19 cwt (9,094 kg) rear
Adhesive weight 62 LT 18 cwt (63,910 kg)
Loco weight 99 LT 14 cwt (101,300 kg)
Fuel type Coal
Fuel capacity 5 LT (5.1 t)
Water cap 2,080 imp gal (9,460 l) front
920 imp gal (4,180 l) rear
Firebox type Belpaire
  Firegrate area 34 sq ft (3.2 m2)
Boiler:
  Pitch 7 ft 3 in (2,210 mm)
  Diameter 5 ft 1 34 in (1,568 mm)
  Tube plates 11 ft 3 38 in (3,439 mm)
  Small tubes 143: 2 in (51 mm)
  Large tubes 24: 5 12 in (140 mm)
Boiler pressure 180 psi (1,241 kPa)
Safety valve Ramsbottom
Heating surface 1,387 sq ft (128.9 m2)
  Tubes 1,232 sq ft (114.5 m2)
  Firebox 155 sq ft (14.4 m2)
Superheater:
  Heating area 280 sq ft (26 m2)
Cylinders Four
Cylinder size 14 in (356 mm) bore
23 in (584 mm) stroke
Valve gear Walschaerts
Valve type Piston
Couplers Bell link-and-pin
Performance figures
Tractive effort 28,470 lbf (126.6 kN) @ 75%
Career
Operators South African Railways
Class Class FC
Number in class 1
Numbers 2310, renumbered 670
Delivered 1925
First run 1925
Withdrawn 1939

The South African Railways Class FC 2-6-2+2-6-2 of 1925 was an articulated steam locomotive.

In 1925, the South African Railways placed a single experimental Class FC Modified Fairlie articulated steam locomotive with a 2-6-2+2-6-2 Double Prairie type wheel arrangement in service.[1][2][3]

Manufacturer

To obtain experience with another type of articulated locomotive similar to the Garratt design, Colonel F.R. Collins DSO, Chief Mechanical Engineer of the South African Railways (SAR), was authorised to experiment with a modified type of Fairlie locomotive. The sole experimental Class FC 2-6-2+2-6-2 Double Prairie type Modified Fairlie locomotive was designed and built for the SAR by the North British Locomotive Company in 1924. It was numbered 2310 upon delivery during February 1925, but it was later renumbered to 670.[1][2][3][4]

The Fairlie locomotive

The Fairlie locomotive was invented and patented in 1864 by the Scottish engineer Robert Francis Fairlie.[5][6]

Double Fairlie

The first Fairlie locomotives later became known as Double Fairlies. In general appearance, most of them were reminiscent of the German-built Zwillinge, which saw service on the narrow gauge lines in South West Africa and other German territories. However, while the Zwillinge were pairs of individual locomotives which were semi-permanently coupled back-to-back, the Double Fairlie was a single locomotive with either a double-ended boiler or two separate boilers, with smokeboxes at each end, a central firebox and a central cab, all mounted on one rigid frame. It ran on two swiveling engine units or powered bogies, similar to those of a Garratt locomotive, with the cylinders on each engine unit at the respective locomotive ends. Couplers, buffers and, where they were in use, cowcatchers were mounted on the engine units so that they could more accurately follow the curvature of the track.[5][6]

Single Fairlie

A variation of the Fairlie concept was the Single Fairlie, also known as the Mason Fairlie. The Single Fairlie design was essentially half a Double Fairlie. It retained the ability to negotiate sharp curves and, while it abandoned the bidirectional nature of the Double Fairlie, it regained the ability of conventional locomotives to have a large water and coal bunker behind the cab and to use a trailing tender if necessary.[5][6]

Swindon Marlborough & Andover Railway Single Fairlie, c. 1878

Early Single Fairlies were similar in appearance to tank locomotives. They differed by virtue of the fact that the whole engine and bunker or tender combination was mounted on a single rigid frame, as on the conven­tional tank engine, with the pivoting engine unit mounted under the boiler and the unpowered bogie under the bunker or tender.[5][6]

Mason Bogie Single Fairlie, c. 1874

Later models were similar in appearance to conven­tional tender locomotives. It was developed by William Mason in the United States of America, where the type became known as the Mason Bogie. It had one boiler, a cab and bunker at one end, a single engine unit or powered bogie under the boiler and an unpowered bogie under the cab and bunker.[5][6]

Modified Fairlie

The first Modified Fairlie was introduced in South Africa and was viewed as a competitor and alternative to the Garratt type. Colonel Collins displayed a distinct preference for articulated locomotives and the Modified Fairlie was acquired as an experimental locomotive in 1925, to compare its concept to that of the Garratt locomotive in terms of actual performance and maintenance requirements.[1][2][3]

The Class FC Modified Fairlie was, in essence, an adaptation of the Kitson-Meyer concept. It was similar in appearance to a Garratt, but with the boiler, cab, coal and water bunkers all mounted on a single rigid frame, which extended almost over the full length of the locomotive. This superstructure was supported on two engine units by means of pivot centres, located approximately at the centre of the coupled wheelbase of each engine unit. In the Garratt design, by comparison, the coal and water bunkers are mounted directly on the engine units and pivot with them, while the boiler, firebox and cab are mounted on a rigid cradle frame which is suspended between the two engine units.[1][2][3][7]

On the Modified Fairlie, as compared to the Double Fairlie, the distance between the engine units had been increased similarly to that of the Garratt type, thereby allowing space between them for a liberal firebox and ashpan. This resulted in a more efficient boiler and also distributed the weight of the engine over a greater length than was obtainable with an orthodox Double Fairlie design. It was claimed that the Modified Fairlie arrangement reduced the wear between wheel flanges and rails, and that the distribution of the loads on the axles, as fuel and water was expended, was less variable than could be obtained with the Garratt design.[2]

Characteristics

The superheated Class FC had 7 inches (178 millimetres) diameter piston valves, actuated by Walschaerts valve gear, and a plate frame, 78 inch (22 millimetres) thick. The aim with the experimental locomotive was to compare the performance and maintenance requirements of the Modified Fairlie to that of a Garratt, in particular to the Class GC 2-6-2+2-6-2 Double Prairie type Garratt, which was similar in both size and mechanical respects. Hence, also, the experimental Modified Fairlie's Class FC designation, skipping the FA and FB classifications which were never used by the SAR.[2][3]

Service

The locomotive was placed in service on the Cape Midlands System. While it gave good service, it was not outstanding and proved to be not as successful as the Garratt. The 63 feet (19.2 metres) long frame resulted in severe overhang on sharp curves. The heavily laden overhangs beyond the pivots also led to metal fatigue due to its tendency to oscillate up-and-down. The pivot bearings, which carried a considerable additional load compared to those on the Garratt, as a result of the water and coal bunkers which were mounted on the long main frame instead of on the engine units, were also subject to quite rapid wear. These factors resulted in increased frequency of maintenance and, as a consequence, increased operating cost.[1][3][7]

No more of the Class FC locomotive was ordered. The sole locomotive was scrapped in 1939, after a comparatively short service life of only fourteen years.[1][2][3]

References

  1. 1 2 3 4 5 6 Holland, D.F. (1972). Steam Locomotives of the South African Railways, Volume 2: 1910-1955 (1st ed.). Newton Abbott, Devon: David & Charles. pp. 44–45. ISBN 978-0-7153-5427-8.
  2. 1 2 3 4 5 6 7 Espitalier, T.J.; Day, W.A.J. (1945). The Locomotive in South Africa - A Brief History of Railway Development. Chapter VII - South African Railways (Continued). South African Railways and Harbours Magazine, December 1945. pp. 967-968.
  3. 1 2 3 4 5 6 7 Paxton, Leith; Bourne, David (1985). Locomotives of the South African Railways (1st ed.). Cape Town: Struik. p. 97. ISBN 0869772112.
  4. North British Locomotive Company works list, compiled by Austrian locomotive historian Bernhard Schmeiser
  5. 1 2 3 4 5 "Garrattfan's Modelrailroading Pages - Articulation - The Semmering Contest". Modelrailroading.nl. Retrieved 2013-09-06.
  6. 1 2 3 4 5 "Garrattfan's Modelrailroading Pages - Articulation - Fairlie". Modelrailroading.nl. Retrieved 2016-05-04.
  7. 1 2 Durrant, A E (1989). Twilight of South African Steam (1st ed.). Newton Abbott, London: David & Charles. p. 31. ISBN 0715386387.
Wikimedia Commons has media related to South African Class FC (2-6-2+2-6-2).
This article is issued from Wikipedia - version of the 9/12/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.