Bus stop

For other uses, see Bus stop (disambiguation).
Moments before the bus arrives, riders wait at State University of New York at Purchase

A bus stop is a designated place where buses stop for passengers to board or alight from a bus. These are normally positioned on the highway and are distinct from off-highway facilities such as bus stations. The construction of bus stops tends to reflect the level of usage. Stops at busy locations may have shelters, seating and possibly electronic passenger information systems; less busy stops may use a simple pole and flag to mark the location and "customary stops" have no specific infrastructure being known by their description. Bus stops may be clustered together into transport hubs allowing interchange between routes from nearby stops and with other public transport modes.

Types of service

A Highway Bus Stop in Visakhapatnam, India

For operational purposes, there are three main kinds of stops: Scheduled stops, at which the bus should stop irrespective of demand; request stops (or flag stop), at which the vehicle will stop only on request; and hail and ride stops, at which a vehicle will stop anywhere along the designated section of road on request.

Certain stops may be restricted to "set-down only" or "pick-up only". Some stops may be designated as "timing points", and if the vehicle is ahead of schedule it will wait there to ensure correct synchronization with the timetable. In dense urban areas where bus volumes are high, skip-stops are sometimes used to increase efficiency and reduce delays at bus stops. Fare stages may also be defined by the location of certain stops in distance or zone-based fare collection systems. Sunday stops are close to a church and used only on Sundays.[1]


The first ever recorded bus stop was in Bishops Stortford and was believed to be constructed in 1890, this linked Bishops Stortford to the town of Colchester.


Bus stop sign in Hamburg with line numbers and major stops

Bus stop infrastructure ranges from a simple pole and sign, to a rudimentary shelter, to sophisticated structures. The usual minimum is a pole mounted flag with suitable name/symbol. Bus stop shelters may have a full or partial roof, supported by a two, three or four sided construction. Modern stops are mere steel and glass/perspex constructions, although in other places, such as rural Britain, stops may be wooden brick or concrete built.Bus stop in Western Isles

The construction may include small inbuilt seats. The construction may feature advertising, from simple posters, to complex illuminated, changeable or animated displays. Some installations have also included interactive advertising. Design and construction may be uniform to reflect a large corporate or local authority provider, or installations may be more personal or distinctive where a small local authority such as a parish council is responsible for the stop. The stop may include separate street furniture such as a bench, lighting and a trash receptacle.

Individual bus stops may simply be placed on the sidewalk next to the roadway, although they can also be placed to facilitate use of a busway. More complex installations can include construction of a bus turnout or a bus bulb, for traffic management reasons, although use of a bus lane can make these unnecessary. Several bus stops may be grouped together to facilitate easy transfer between routes. These may be arranged in a simple row along the street, or in parallel or diagonal rows of multiple stops. Groups of bus stops may be integral to transportation hubs. With extra facilities such as a waiting room or ticket office, outside groupings of bus stops can be classed as a rudimentary bus station.

Convention is usually for the bus to draw level with the 'flag', although in areas of mixed front and rear entrance buses, such as London, a head stop, and more rarely a tail stop, indicates to the driver whether they should stop the bus with either the rear platform or the drivers cab level with the flag.[2]

In certain areas, the area of road next the bus stop may be specially marked, and protected in law. Often, car drivers can be unaware of the legal implications of stopping or parking in a bus-stop.[3]

In bus rapid transit systems, bus stops may be more elaborate than street bus stops, and can be termed 'stations' to reflect this difference. These may have enclosed areas to allow off-bus fare collection for rapid boarding, and be spaced further apart like tram stops. Bus stops on a bus rapid transit line may also have a more complex construction allowing level boarding platforms, and doors separating the enclosure from the bus until ready to board.


Bus stop info poster in Vancouver, British Columbia also shows rapid transit routes

Public facing information

Most bus stops are identified with a metal sign attached to a pole or light standard. Some stops are plastic strips strapped on to poles and others involve a sign attached to a bus shelter. The signs are often identified with a picture of a bus and/or with the words "bus stop" (or similar in non-English-speaking places).

The bus stop "flag" (a panel usually projecting from the top of a bus stop pole) will sometimes contain the route numbers of all the buses calling at the stop, optionally distinguishing frequent, infrequent, 24-hour, and night services. The flag may also show the logo of the dominant bus operator, or the logo of a local transit authority with responsibility for bus services in the area. Additional information may include an unambiguous, unique name for the stop, and the direction/common destination of most calling routes.

Bus stops will often include timetable information, either the full timetable, or for busier routes, the times or frequency that a bus will call at the specific stop. Route maps and tariff information may also be provided, and telephone numbers to relevant travel information services.

The stop may also incorporate, or have nearby, real time information displays with the arrival times of the next buses. Increasingly, mobile phone technology is being referenced on more remote stops, allowing the next bus times to be sent to a passenger's handset based on the stop location and the real time information. Automated ticket machines may be provided at busy stops.

Data model

Modern passenger information systems and journey planners require a detailed digital representation of the stops and transportation hubs. The CEN Transmodel data model, and the related IFOPT data interchange standard, define how transport systems, including bus stops, should be described for use in computer models. In Transmodel, a single bus stop is modeled as a "Stop Point", and a grouping of nearby bus stops as a "Stop Area" or "Stop Place". The General Transit Feed Specification (GTFS) standard, originally developed by Google, defines a simple and widely used data interchange standard for public transport schedules. GTFS also includes a table of Stop Points which gives a name, identifier, and location for each bus stop. OpenStreetMap has a modeling standard for bus stops.[4]

The United Kingdom has collected a complete database of its public transport access points, including bus stops, into the National Public Transport Access Nodes (NaPTAN) database with details of 350,000 nodes and which is available as open Data from data.gov.uk.[5]


Neglected bus shelter needing repair

Bus stops enhance passenger safety in a number of ways:


Sign marking a temporary bus stop in London

Some jurisdictions have introduced particularised legislative controls to foster safer bus stop design and management. The State of Victoria, Australia, for example, has enacted a Bus Safety Act which contains performance-based duties of care[7] which apply to all industry participants who are in a position to influence the safety of bus operations - what is called the "chain of responsibility". The safety duties apply to all bus services, both commercial and non-commercial, and to all buses regardless of seating capacity. Breach of the duty is a serious criminal offence which carries a heavy penalty.

The primary duty holder under the Bus Safety Act is the operator of the bus service, as the person who has effective responsibility and control over the whole operation.[8] However, the Act also contains a safety duty covering "people with responsibility for bus stops", including people who design, build, or maintain the stop, plus those who decide on its location.[9]

This duty was introduced in response to research showing that the most serious hazard associated with bus travel occurs when passengers, especially children, are crossing the road after alighting from the bus. The location and layout of a bus stop is therefore a factor in the level of risk.[10]

Safety duties are also imposed by the Bus Safety Act on a range of other people including -

All of these persons can clearly affect bus safety. They are required by the Bus Safety Act to ensure that, in carrying out their activities, they eliminate risks to health and safety if 'practicable' - or work to reduce those risks 'so far as is reasonably practicable'. This familiar practicability formula is borrowed from Victoria's Rail Safety Act (and a subsequent national model Rail Safety Bill) and the Occupational Health and Safety Act 2004.


Many transit agencies have developed guidelines for preferred bus stop spacing. In most US cities, however, the typical bus stop spacing is between 650 and 900 feet (200–275 m), well below the optimal.

Bus stop vehicle capacity is often an important consideration in the planning of bus stops serving multiple routes within urban centers. Limited capacity may mean buses queue up behind each other at the bus stop, which can cause traffic blockages or delays. Bus stop capacity is typically measured in terms of buses/hour that can reliably use the bus stop. The main factors that affect bus stop capacity are:

Detailed procedures for calculating bus stop capacity and bus lane capacity using skip stops are outlined in Part 4 of the Transit Capacity and Quality of Service Manual, published by the US Transportation Research Board.

Transit agencies are increasingly looking at consolidation of possibly previously haphazardly placed bus stops as a way to improve service cheaply and easily. Bus stop consolidation evaluates the bus stops along an established bus route and develops a new pattern for optimal bus stop placement. Bus stop consolidation has been proven to improve operating efficiency and ridership on bus routes.

Pantographs and underbody collectors

Pantographs and underbody collectors are integrated in bus stops to quick electric bus recharge, making possible to use a smaller battery on the bus, which reduces the investment and subsequent costs.[13][14][15]

Fake bus stops

Some nursing homes have built fake, imitation bus stops for their residents who have dementia.[16] Some of these bus stops are even fitted with outdated advertisements and timetables – 30 years outdated.[16] The residents will sit at the bus stop waiting for a bus to take them to their imagined destination.[16] After some time, a staff member comes to escort the clients back to the home.[16]

Bus stops are common tropes in popular culture. In 1956 there was a Marilyn Monroe film called Bus Stop. A famous scene in the movie Forrest Gump takes place at a bus stop and almost all episodes of South Park series start by presenting the main characters in a bus stop.

In Japanese culture, the movie My Neighbor Totoro featured a bus stop, both for ordinary buses and a cat bus. The opening scene of the anime Air shows the main character getting off at a bus stop. The Japanese movie Summer Wars features a rural bus stop.

Renowned rabbis have taught lessons in Judaism from their interaction and experience with bus stops.[17][18][19][20][21][22]

See also


  1. Andrew-Gee, Eric (7 May 2015). "Sunday streetcar stops near churches to be shuttered in June". Toronto Star. Retrieved 11 May 2015.
  2. London Transport historical bus stop signs
  3. Nottingham city transport Archived July 16, 2007, at the Wayback Machine. Bus Lanes and Bus Stops - what's the problem?
  4. "Bus Stop". OpenStreetMap. Retrieved 2010-03-25.
  5. "National Public Transport Access Nodes (NaPTAN)". data.gov.uk.
  6. http://www.vestische.de/halten-auf-wunsch/articles/halten-auf-wunsch.html (Example for one such regulation, in German)
  7. Bus Safety Act 2009, Part 3.
  8. Bus Safety Act 2009, section 15.
  9. Bus Safety Act 2009, section 18.
  10. See Improving Bus Safety in Victoria, a discussion paper published by the Department of Transport in May 2009.
  11. Bus Safety Act 2009, section 17.
  12. Bus Safety Act 2009, section 16.
  13. Current collectors for electric busses
  14. A Giant Charger That Juices Up Electric Buses in Three Minutes
  15. Ultrafast Electric Bus Charging, Opbrid
  16. 1 2 3 4 Paulick, Jane. "Bus-Stops at Old People's Homes Take Patients for a Ride". Deutsche Welle. June 6, 2008. Retrieved June 8, 2008.
  17. B. C. Glaberson (1 June 1999). The life and times of Reb Rephoel Soloveitchik of Brisk. Feldheim. p. 96. ISBN 978-1-58330-361-0. Retrieved 10 October 2010.
  18. Rav Shlomo Zalman Auerbach, Yated Neeman
  19. Nisson Wolpin (2002). Torah leaders: a treasury of biographical sketches collected from the pages of the Jewish Observer. Mesorah Publications in conjunction with Agudath Israel of America. p. 243. ISBN 978-1-57819-773-6. Retrieved 6 October 2010.
  20. A. L. Scheinbaum (February 1998). Peninim on the Torah. Peninim Publications in conjunction with "The Living Memorial," a project of the Hebrew Academy of Cleveland. p. 138. ISBN 978-0-9635120-6-2. Retrieved 10 October 2010.
  21. Yonason Rosenblum (2000). Rav Dessler: the life and impact of Rabbi Eliyahu Eliezer Dessler the Michtav m'Eliyahu. Mesorah. p. 66. ISBN 978-1-57819-506-0. Retrieved 10 October 2010.
  22. The Power of his example
This article is issued from Wikipedia - version of the 11/18/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.