Briggs–Rauscher reaction

Oscillogram made in July 1972 by Briggs and Rauscher.

The Briggs–Rauscher oscillating reaction is one of a small number of known oscillating chemical reactions. It is especially well suited for demonstration purposes because of its visually striking colour changes: the freshly prepared colourless solution slowly turns an amber colour, suddenly changing to a very dark blue. This slowly fades to colourless and the process repeats, about ten times in the most popular formulation, before ending as a dark blue liquid smelling strongly of iodine.

History

The first known homogeneous oscillating chemical reaction, reported by W. C. Bray in 1921,[1] was between hydrogen peroxide (H2O2) and iodate (IO3) in acidic solution. Due to experimental difficulty, it attracted little attention and was unsuitable as a demonstration. In 1958 B. P. Belousov in the Soviet Union discovered the Belousov–Zhabotinsky reaction (BZ reaction),[2] which is suitable as a demonstration, but it too met with skepticism (largely because such oscillatory behaviour was unheard of up to that time) until A. M. Zhabotinsky, also in the USSR, learned of it and in 1964 published his research.[3] In May 1972 a pair of articles in the Journal of Chemical Education[4][5] brought it to the attention of two science instructors at Galileo High School in San Francisco. They discovered the BriggsRauscher oscillating reaction[6] by replacing bromate (BrO3) in the BZ reaction with iodate and adding hydrogen peroxide. They produced the striking visual demonstration by adding starch indicator. Since then, many other investigators have added to the knowledge and uses of this very unusual reaction.

Description

Initial conditions

The initial aqueous solution contains hydrogen peroxide, an iodate, divalent manganese (Mn2+) as catalyst, a strong chemically unreactive acid (sulphuric acid (H2SO4) or perchloric acid (HClO4) are good), and an organic compound with an active ("enolic") hydrogen atom attached to carbon which will slowly reduce free iodine (I2) to iodide (I). (Malonic acid (CH2(COOH)2) is excellent for that purpose.) Starch is optionally added as an indicator to show the abrupt increase in iodide ion concentration as a sudden change from amber (free iodine) to dark blue (the "iodine-starch complex", which requires both iodine and iodide.)[7] Recently it has been shown, however, that the starch is not only a simple indicator for iodine in the reaction.[8] In the presence of starch the number of oscillations are higher and the period times are longer compared to the starch-free mixtures. It was also found that the iodine consumption segment within one period of oscillation is also significantly longer in the starch containing mixtures. This suggests that the starch probably acts as a reservoir for the iodine and iodide due to the starch-triiodide equilibrium, thereby modifying the kinetics of the steps in which iodine and iodide are involved. In the same study, a method was presented for minimizing the environmental impact of the reaction mixture before its disposal. The residual mixture contains iodinated malonic acid, inorganic acid, manganous catalysts, unreacted iodate and hydrogen peroxide. After the oscillations cease, the iodomalonic acid decomposes and iodine is produced. The rate of decomposition depends on the conditions. All of the components present in the residual mixture are of environmental concern: Iodate, iodine and hydrogen peroxide are strong oxidants, the acid is corrosive and manganese has been suggested to cause neurological disorders (citation needed). A simple method has been developed employing thiosulfate and carbonate – two inexpensive salts – to remove all oxidants, neutralize the acidity and recover the manganous ion in the form of manganese dioxide. The reaction is "poisoned" by chloride (Cl) ion, which must therefore be avoided, and will oscillate under a fairly wide range of initial concentrations. For recipes suitable for demonstration purposes, see Shakhashiri[9] or Preparations in the external links.

Behaviour in time

Video of Briggs–Rauscher reaction

The reaction shows recurring periodic changes, both gradual and sudden, which are visible: slow changes in the intensity of colour, interrupted by abrupt changes in hue. This demonstrates that a complex combination of slow and fast reactions are taking place simultaneously. For example, following the iodide ion concentration with a silver/silver iodide electrode[6] (see Videos) shows sudden dramatic swings of several orders of magnitude separated by slower variations. This is shown by the oscillogram above. Oscillations persist over a wide range of temperatures. Higher temperatures make everything happen faster, with some qualitative change observable (see Effect of temperature). Stirring the solution throughout the reaction is helpful for sharp colour changes, otherwise spatial variations may develop (see Videos). Bubbles of free oxygen are evolved throughout, and in most cases, the final state is rich in free iodine

Variants

Changing the initial concentrations

As noted above, the reaction will oscillate in a fairly wide range of initial concentrations of the reactants.[10] For oscillometric demonstrations, more cycles are obtained in dilute solutions, which produce weaker colour changes. See for example the graph, which shows more than 40 cycles in 8 minutes.

Changing the organic substrate

Malonic acid has been replaced by other suitable organic molecules,[11] such as acetone (CH3COCH3) or 2,4 Pentanedione (CH3COCH2COCH3) ("acetylacetone"). More exotic substrates have been used.[12][13] The resulting oscillographic records often show distinctive features, for example as reported by Szalai.

Continuous flow reactors

The reaction may be made to oscillate indefinitely by using a continuous flow stirred tank reactor (CSTR), in which the starting reagents are continuously introduced and excess fluid is drawn.[14][15]

Two dimensional phase space plots

By omitting the starch and monitoring the concentration of I2 photometrically, (i.e., measuring the absorption of a suitable light beam through the solution) while simultaneously monitoring the concentration of iodide ion with an iodide-selective electrode, a distorted spiral XY-plot will result. In a continuous-flow reactor, this becomes a closed loop (limit cycle).

Fluorescent demonstration

By replacing the starch with a fluorescent dye, Weinberg and Muyskens (2007) produced a demonstration visible in darkness under UV illumination.[16]

Use as a biological assay

The reaction has been proposed as an assay procedure for antioxidants in foodstuffs.[17] The sample to be tested is added at the onset of oscillations, stopping the action for a period proportional to its antioxidant activity. Compared to existing assay methods, this procedure is quick and easy and operates at the pH of the human stomach.[18] For a detailed description suitable for high school chemistry, see Preparations. In contrast to the findings referring predominantly to polyphenolic compounds reported in the above cited literature, it was found that the salicylic acid – a simple monophenolic compound – did not stop the oscillations immediately after it was added into the active Briggs-Rauscher mixture.[19] In the low concentration interval the salicyclic acid only damped the oscillations, while in higher concentrations the damping effect was much stronger and complete inhibition was also observed.[20] It is also interesting that the sulfosalicylic acid, a derivative of salicyclic acid practically did not affect the oscillations.

Chemical mechanism

The detailed mechanism of this reaction is quite complex.[10][21] Nevertheless, a good general explanation can be given.

For best results, and to prevent side reactions that may interfere with the main reaction, the solutions are best prepared a short time before the reaction. If left undisturbed, or exposed to ultra-violet radiation the reactants can decompose or react with themselves, interfering with the process.

The essential features of the system depend on two key processes (These processes each involve many reactions working together):

But process B can operate only at low concentrations of iodide, creating a feedback loop as follows:

Initially, iodide is low and process B generates free iodine, which gradually accumulates. Meanwhile, process A slowly generates the intermediate iodide ion out of the free iodine at an increasing rate proportional to its (i.e. I2) concentration. At a certain point, this overwhelms process B, stopping the production of more free iodine, which is still being consumed by process A. Thus, eventually the concentration of free iodine (and thus iodide) falls low enough for process B to start up again and the cycle repeats as long as the original reactants hold out.

The overall result of both processes is (again, approximately):[10]

IO3 + 2H2O2 + CH2(COOH)2 + H+ ICH(COOH)2 + 2O2 + 3H2O

The colour changes seen during the reaction correspond to the actions of the two processes: the slowly increasing amber colour is due to the production of free iodine by process B. When process B stops, the resulting increase in iodide ion enables the sudden blue starch colour. But since process A is still acting, this slowly fades back to clear. The eventual resumption of process B is invisible, but can be revealed by the use of a suitable electrode.[6]

A negative feedback loop which includes a delay (mediated here by process A) is a general mechanism for producing oscillations in many physical systems, but is very rare in nonbiological homogeneous chemical systems. (The BZ oscillating reaction has a somewhat similar feedback loop.)

External links

Videos

Effect of temperature

Preparations

References

  1. W. C. Bray (1921). "A Periodic Reaction in Homogeneous Solution and Its Relation to Catalysis". J. Am. Chem. Soc. 43 (6): 1262–1267. doi:10.1021/ja01439a007.
  2. Belousov, B. P. (1958), "A Periodic Reaction and Its Mechanism", Sbornik Referatov po Radiatsionni Meditsine, Medgiz, Moscow, p. 145. (transl. in Field and Burger, Op.Cit., below)
  3. Zhabotinskii, A. M. (1964). Периодические окислительные реакции в жидкой фазе [Periodic oxidation reactions in liquid phase]. Doklady Akademii Nauk SSSR (in Russian). 157 (2): 392–393.
  4. Field, R. J. (1972), "A Reaction Periodic in Time and Space", J. Chem. Educ., 49, 308.
  5. Degn, Hans (1972), "Oscillating Chemical Reactions in Homogeneous Phase", J. Chem. Educ., 49, 302307.
  6. 1 2 3 Thomas S. Briggs and Warren C. Rauscher (1973), "An Oscillating Iodine Clock", J. Chem. Educ. 50, 496.
  7. J. A. Thoma & D. French (1960). "The Starch-Iodine-Iodide Interaction. Part I. Spectrophotometric Investigations". J. Am. Chem. Soc. 82 (16): 4144–4147. doi:10.1021/ja01501a004.
  8. L. I. Csepei & Cs. Bolla (2015). "Is starch only a visual indicator for iodine in the Briggs-Rauscher oscillating reaction?" (PDF). Studia UBB Chemia. 60 (2): 187–199.
  9. Shakhashiri, B. Z. (1992) Chemical Demonstrations: A Handbook for Teachers of Chemistry Vol. II pp 248256, University of Wisconsin Press, Madison, WI.
  10. 1 2 3 Furrow, S. D. in Field, R. J. and M. Burger(1985), Oscillations and Traveling Waves in Chemical Systems, J. Wiley & Sons, New York.
  11. S. D. Furrow (1995). "Comparison of Several Substrates in the BriggsRauscher Oscillating System". J. Phys. Chem. 99 (28): 11131–11140. doi:10.1021/j100028a013.
  12. Furrow, Stanley D.; Cervellati, Rinaldo; Amadori, Giovanna (2002). "NewSubstrates for the Oscillating BriggsRauscher Reaction". J. Phys. Chem. A. 106: 5841–5850. doi:10.1021/jp0138779.
  13. Szalai, Istvan; Szalai, Istvan (August 2006). "BriggsRauscher Reaction with 1,4-Cyclohexanedione Substrate". Z. Phys. Chem. 220 (8): 1071–1082. doi:10.1524/zpch.2006.220.8.1071.
  14. A. Pacault; P. Hanusse; P. De Kepper; C. Vidal; J. Boissonade (1976). "Phenomena in homogeneous chemical systems far from equilibrium". Acc. Chem. Res. 9 (12): 438–445. doi:10.1021/ar50108a003.
  15. Merino, J. M.(1992), "A simple,continuous-flow stirred-tank reactor for the demonstration and investigation of oscillating reactions", J. Chem. Educ. 69, p. 754.
  16. Weinberg, Richard B.; Mark Muyskens (2007). "An Iodine Fluorescence Quenching Clock Reaction". J. Chem. Educ. 84: 797. Bibcode:2007JChEd..84..797W. doi:10.1021/ed084p797.
  17. R. Cervellati; K. Höner; Stanley D. Furrow; C. Neddens; S. Costa (2001). "The BriggsRauscher Reaction as a Test to Measure the Activity of Antioxidants". Helvetica Chimica Acta. 84 (12): 3533–3547. doi:10.1002/1522-2675(20011219)84:12<3533::AID-HLCA3533>3.0.CO;2-Y.
  18. R. Cervellati, C. Renzulli, M. C. Guerra and E. Speroni (2002). "Evaluation of Antioxidant Activity of Some Natural Polyphenolic Compounds Using the BriggsRauscher Reaction Method". J. Agric. Food Chem. 50 (26): 7504–7509. doi:10.1021/jf020578n.
  19. L. I., Csepei; Cs., Bolla. "Study on the Inhibition of Briggs-Rauscher Oscillating Reaction" (PDF). Studia UBB Chemia. 4 (II): 249.
  20. L.I., Csepei; Cs., Bolla. "The Effect of Salicylic Acid on the Briggs-Rauscher Oscillating Reaction" (PDF). Studia UBB Chemia. 1: 285.
  21. R. M. Noyes & S. D. Furrow (1982). "The oscillatory BriggsRauscher reaction. 3. A skeleton mechanism for oscillations". J. Am. Chem. Soc. 104 (1): 45–48. doi:10.1021/ja00365a011.
This article is issued from Wikipedia - version of the 11/25/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.