A Travan tape cartridge shown next to a CD-R disc.
The internals of a 20GB Travan tape cartridge.

Travan is an 8 mm magnetic tape cartridge design developed by the 3M company, used for the storage of data in computer backups and mass storage.[1] Over time, subsequent versions of Travan cartridges and drives have been developed that provide greater data capacity, while retaining the standard 8 mm width and 750' length. Travan is standardized under the QIC body. HP Colorado, Iomega DittoMax and AIWA Bolt are proprietary versions of the Travan format.[2]

The Travan format competes mainly against the DDS, AIT, and VXA formats.


Generation TR-1 TR-3 TR-4 TR-5/NS20 TR-7
Release date 1995 1995 1997 1998 2002
Data capacity 400 MB 1.6 GB 4 GB 10 GB 20 GB
Max speed (MB/s) 0.25 0.5 1.2 2 4
Media format QIC-80 QIC-3020 QIC-3095 QIC-3220-MC Travan 640
Min tape length (ft) 750 750 740 740 750
Tape tracks 36 50 72 108 108
Encoding MFM MFM RLL(1,7) RLL(1,7) VR2 (PRML)
Tape type Co-γFe2O3 Co-γFe2O3 Co-γFe2O3 Metal Particle Metal Particle
Coercivity (Oe) 550 900 900 1650 1650
Recording density (ftpi) 14,700 44,250 50,800 79,800 96,000
Data density (bpi) 14,700 44,250 67,733 106,400 192,000[3]






An external, USB, NS20 Travan tape drive.



Travan uses a linear track technology, with data written onto individual tracks over several successive passes. Fully reading or writing a tape to full capacity may require moving the tape from reel to reel many times. The tape is not attached to the hubs, but is wrapped and held by friction. The tape is prevented from coming off at the ends using small holes punched in the tape, which are detected by optical sensors in the tape drive using a 45-degree mirror inside and a window on the side the cartridge.

It also uses an indirect tension-band drive system, consisting of an elastic band that presses on the exterior of both reels, and also over an idler wheel on the edge of the case. A motor in the drive contacts the idler to move the tape. Because the reels wind and unwind at unequal speeds there is always some slippage occurring when the tape is in motion. Old tapes used many times tend to have a visibly marked stripe down the center of the tape where the band has pressed into the tape.

Unlike some competing technologies such as Digital Linear Tape (DLT) and Linear Tape-Open (LTO), Travan technology does not automatically verify data after writing. Data verification must be done separately by the computer operator, to verify data was written successfully. If a separate verify operation is not performed after each backup, it is possible for backups to be found to be corrupt and unusable when the tapes need to be used.


  1. Scott Mueller (2004). Upgrading and Repairing PCs. p. 683. ISBN 0789731738.
  2. Scott Mueller (2003). Upgrading and Repairing PCs. Que. p. 684. ISBN 0789729741.
  3. Seagate Travan 40 Product Manual (PDF). Seagate Removable Storage Solutions LLC. 2002. p. 5.

External links

This article is issued from Wikipedia - version of the 9/4/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.