Stab vest

For the type of buoyancy compensator used in scuba diving, see stab jacket.
An armed British police officer wearing a stab vest
CSPBA

A stab vest, or stab proof vest is a reinforced piece of body armor, worn under or over other items of clothing, which is designed to resist knife attacks to the chest, back and sides. Stab vests are different from bulletproof vests, most of which offer protection against firearms but afford little against stabbing with sharp-tipped objects such as knives; most stab vests afford less protection against bullets, particularly those of high caliber, but are designed to prevent serious injury by prohibiting knife penetration beyond a few millimeters. Stab vests are also needle and slash proof.

Standards

"Ice pick" tests

In the mid-1980s the state of California Department of Corrections issued a requirement for a body armor using a commercial ice pick as the test penetrator. The test method attempted to simulate the capacity of a human attacker to deliver impact energy with their upper body. As was later shown this test over stated the capacity of human attackers. The test used a drop mass or sabot that carried the ice pick. Using gravitational force, the height of the drop mass above the vest was proportional to the impact energy. This test specified 109 joules (81 ft·lbf) of energy and a 7.3 kg (16 lb) drop mass with a drop height of 153 cm (60 in) and an ice pick with a 4 mm (0.16 in) diameter with a sharp tip with a 5.4 m/s (17 ft/s) terminal velocity in the test. The California standard did not include knife or cutting edge weapons in the test protocol. In this early phase only titanium and steel plate offerings were successful in addressing this requirement.

It should be noted that these textile materials do not have equal performance with cutting-edge threats and these certifications were only with ice picks and were not tested with knives.

UK

The PSDB work studied what kind of weapons are commonly used in stabbing attacks and what levels of impact energy fit young men are capable of generating during an attack. The study resulted in minimum performance ratings for armor used in the UK, as defined under PSDB publication 6/99. The PSDB standard was replaced in 2007 with the current Home Office Scientific Development Branch (HOSDB) publication No. 39/07/C which governs stab resistant body armor performance in the UK. This updated standard introduced a more stringent testing procedure with more drops than the previous standard plus the introduction of the P1/B Blade which is found to be more aggressive that the older P1/A Blade.[1]

In the UK there are no standalone ratings for spike resistance. For stab resistant armor to carry a spike resistance (SP) rating in the UK, it must first pass minimum knife resistance (KR) performance tests.

US

In the US, the National Institute of Justice (NIJ) has established a stab resistant body armor test standard (NIJ STD 0115.00), based on the work in the UK, which defines two threat types: spike and edged blade.

Manufacturers of body armor can voluntarily submit armor models for compliance testing through the National Law Enforcement and Corrections Technology Center in Rockville, MD. Through the program, manufacturers certify that their armor will defeat the specified threat at one of three threat levels. Threat levels 1, 2 and 3 are based on impact energies of 24-, 33- and 43-joules respectively.

Use

Stab proof vests are commonly used by police in both the United Kingdom and New Zealand; in both countries it is standard issue to every officer. They are also often worn by paramedics, security staff, traffic wardens, environmental wardens, customs officers, immigration officers, bailiffs, cash in transit officers, door supervisors/bouncers, or anyone who may be under any threat.

Concealable Stab-Protective Body Armor

The Concealable Stab-Protective Body Armor (CSPBA) is a stab vest, worn by United States Army personnel performing law enforcement operations, including confinement of enemy prisoners of war and overseeing civilian internees, for protection against homemade weapons and handguns. The CSPBA provides soft armor protection to the torso against a 9mm, full metal jacket 124-grain bullet and meets the California Ice Pick standard for protection against other crude stab/slash weapons.

See also

References

  1. ↑ "HOSDB Body Armour Standards for UK Police (2007), Part 3: Knife and Spike Resistance 39-07-C", The Home Office

External links

This article incorporates work from https://peosoldier.army.mil/newpeo/Equipment/Temp.asp?id=SPE_CSPBA, which is in the public domain as it is a work of the United States Military.

This article is issued from Wikipedia - version of the 9/18/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.