Similarities between Wiener and LMS

The Least mean squares filter solution converges to the Wiener filter solution, assuming that the unknown system is LTI and the noise is stationary. Both filters can be used to identify the impulse response of an unknown system, knowing only the original input signal and the output of the unknown system.By relaxing the error criterion to reduce current sample error instead of minimizing the total error over all of n, the LMS algorithm can be derived from the Wiener filter.

Derivation of the Wiener filter for system identification

Given a known input signal , the output of an unknown LTI system can be expressed as:

where is an unknown filter tap coefficients and is noise.

The model system , using a Wiener filter solution with an order N, can be expressed as:

where are the filter tap coefficients to be determined.

The error between the model and the unknown system can be expressed as:

The total squared error can be expressed as:

Use the Minimum mean-square error criterion over all of by setting its gradient to zero:

which is for all

Substitute the definition of :

Distribute the partial derivative:

Using the definition of discrete cross-correlation:

Rearrange the terms:

for all

This system of N equations with N unknowns can be determined.

Derivation of the LMS algorithm

By relaxing the infinite sum of the Wiener filter to just the error at time , the LMS algorithm can be derived.

The squared error can be expressed as:

Using the Minimum mean-square error criterion, take the gradient:

Apply chain rule and substitute definition of y[n]

Using gradient descent and a step size :

which becomes, for i = 0, 1, ..., N-1,

This is the LMS update equation.

See also

References

This article is issued from Wikipedia - version of the 11/5/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.