Saddle tank (submarine)

The German submarine U-995 at the German Navy memorial at Laboe, showing the starboard saddle tank as the elongated bulge along the side of the submarine

Saddle tanks are a type of ballast tank configuration fitted to mid-era submarines, those of World War II.

Saddle tanks are fitted in pairs external to the pressure hull, one on each side, in a similar manner to that of a horse's saddle-bags, the positioning of which they resemble in appearance.

Development

Early submarine cross-section, before saddle tanks

The first effective submarines, those of World War I, had hulls that were broadly circular in cross-section, with a deck plate mounted midway. Their heavy battery tanks were mounted beneath this deck, for stability. The ballast tanks were mounted inside the pressure hull. For compactness the ballast tanks were wrapped around the batteries, low down and sharing the flat surfaces of the battery tank.[1] The Kingston valves linking the ballast tanks to the sea could be left open, a practice known as "riding the valves", and the water level in the tanks controlled solely by the vent and blowing air valves. The drawback was that the ballast tanks, open to sea pressure, had a flat surface to the crew compartment and were thus restricted in strength to the bursting strength of this flat plate. In particular this led to accidents where the boat bottomed safely after an accident, but the excess pressure of "blowing out" was sufficient to cause the internal tank wall to fail.[1]

A secondary drawback of these internal ballast tanks could be poor sea-keeping when surfaced. With the tanks full of water the submarine was stable, but when emptied, this large buoyant volume low-down led to excessive rolling. This was made worse, as early submarines also spent almost all of their time surfaced and had little freeboard to begin with.

Development of the saddle tank

The saddle tank was formed by moving the ballast tanks outside the pressure hull.[1] Early designs raised the weather deck and casing above the pressure hull, producing a ballast tank that wrapped around the upper part of the pressure hull (diagrams A & B). Following the terminology of steam railway locomotives, this was termed a "saddle tank". Later designs, notably those of the US Fleet submarines and German U-boats, placed two separate ballast tanks lower down on the sides of the hull (diagram C). In railway practice this would have been a "pannier tank", but for submarines the "saddle" label remained.[note 1]

For some time it remained practice to place the main ballast tanks outside the pressure hull, but to keep the smaller auxiliary tanks inside the hull and below the deck. In the US Navy T-class submarines, this tank wall was at least curved to resist pressure.[2]

Development after World War II

The tanks themselves are usually streamlined to reduce water resistance and are prominent on many submarine designs produced prior to the end of World War II.

Saddle tanks are not fitted to current naval submarine designs, as external fittings are discouraged in order to improve underwater speed and reduce hydrodynamic noise detectable by an enemy's passive sonar. For this reason, post-1945 designs, i.e. post Albacore, usually use internal ballast tanks, which are fitted inside the teardrop pressure hull.

References

  1. A source of some confusion to railway aficionados since.
  1. 1 2 3 Burgess, M.W. (1936). Warships To-day. London: Oxford University Press. pp. 25–26.
  2. Alden, John D. Cdr. "The T Class". The Fleet Submarine in the U.S. Navy. London: Arms and Armour Press. pp. 22–23. ISBN 0-85368-203-8.
This article is issued from Wikipedia - version of the 5/15/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.