SPARCstation 1

SPARCstation 1+ (25 MHz SPARC)

The SPARCstation 1, or Sun 4/60, is the first of the SPARCstation series of SPARC-based computer workstations sold by Sun Microsystems. It had a distinctive slim enclosure (a square 3 inch high "pizza box") and was first sold in April 1989, with Sun's support for it ending in 1995.

Based on a LSI Logic RISC CPU running at 20 MHz, with a Weitek 3167 (or 3170) FPU coprocessor it was the fourth Sun computer (after the 4/260, 4/110 and 4/280) to use the SPARC architecture and the first of the sun4c architecture. The motherboard offered three SBus slots and had built-in AUI ethernet, 8 kHz audio, and a 5 MB/s SCSI-1 bus. The basic display ran at 1152×900 in 256 colours, and monitors shipped with the computer were 16 to 19 inch greyscale or colour.

Designed for ease of production to compete with high-end PCs or Macs, it sold for between about US$9,000 (with no hard disks), to US$20,000 and in the first year around 35,000 units were sold.

Design

The SPARCstation 1 features several distinctive design and packaging elements driven internally by system designer Andy Bechtolsheim and externally by design house frogdesign. Bechtolsheim specified that the motherboard would be the size of a sheet of paper and the SBus expansion cards would be the size of index cards, resulting in an extremely compact footprint. The external design motif includes dot-patterned cooling vents on the side which are echoed by a "dimple" pattern on the front face, and "Sun purple" feet.

Memory

The SPARCstation 1 takes 30 pin SIMMs in groups of four. It can take either 1 MB or 4 MB SIMMs as long as the size is consistent within a bank. There are a total of four memory banks, which can give a total of 64 MB of memory. The memory bank nearest the floppy disk drive should be filled first. If not, the OpenBoot firmware will hang while memory checking.

Disk drives

The SPARCstation 1 has space for up to two hard drives and one floppy drive internally. The machine will take any 50 pin SCSI-2 hard drive, but the OpenBoot firmware will not boot from any partition which starts or ends after 1024 MB. The floppy drive, like the Macintosh's, is unusual in that it has an electromechanical eject mechanism rather than the conventional eject button, and therefore must be ejected by the operating system or OpenBoot. The machine can connect to any SCSI CD drive, via either the SCSI connector on the back or by connecting it to any spare internal SCSI connector via a 50 pin cable.

NVRAM

The SPARCstation 1 uses an M48T02 battery-backed RTC with RAM chip which handles the real time clock and boot parameter storage. The only problem with this chip is that the battery is internal, which means the entire chip must be replaced when its battery runs out. As all SPARCstation 1s made are now older than the battery life of this chip, a substantial number of these systems now refuse to boot. Additionally, the SPARCstation 1 design used the reserved bits in the M48T02's NVRAM in a non-standard way; since later revisions of the M48T02 chip exert stricter control over these bits, a current M48T02 will store the NVRAM data, but the RTC will not function correctly.

Operating systems

The SPARCstation 1, 1+, IPC and SLC can run the following operating systems:

Related computers

The SPARCstation 1+ (Sun 4/65) pushed the CPU to a 25 MHz LSI L64801, upgraded the coprocessor to a Weitek 3172 and installed a new SCSI controller.

The SPARCstation IPC (Sun 4/40) is a version of the SPARCstation 1+ in a lunchbox style case and onboard video.

The SPARCstation SLC (Sun 4/20) is a version of the SPARCstation 1+ built into a monitor cabinet.

The SPARCstation 2 (Sun 4/75) is the machine's successor and was released in 1990.

External links

This article is issued from Wikipedia - version of the 9/4/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.