Reaction control system

Two of four Reaction Control System thruster quads on the Apollo Lunar Module

A reaction control system (RCS) is a spacecraft system that uses thrusters to provide attitude control, and sometimes translation. Use of diverted engine thrust to provide stable attitude control of a short-or-vertical takeoff and landing aircraft, below conventional winged flight speeds, such as the Harrier "jump jet", may also be referred to as a reaction control system.

An RCS is capable of providing small amounts of thrust in any desired direction or combination of directions. An RCS is also capable of providing torque to allow control of rotation (roll, pitch, and yaw).

RCS systems often use combinations of large and small (vernier) thrusters, to allow different levels of response. Spacecraft reaction control systems are used:

Because spacecraft only contain a finite amount of fuel and there is little chance to refill them, some alternative reaction control systems have been developed so that fuel can be conserved. For stationkeeping, some spacecraft (particularly those in geosynchronous orbit) use high-specific-impulse engines such as arcjets, ion thrusters, or Hall effect thrusters. To control orientation, a few spacecraft, including the ISS, use momentum wheels which spin to control rotational rates on the vehicle.

Location of thrusters on spacecraft

Gemini OAMS and Re-entry Control System

The Mercury space capsule and Gemini re-entry module both used groupings of nozzles to provide attitude control. The thrusters were located off their center of gravity, thus providing a torque to rotate the capsule. The Gemini capsule was also capable of adjusting its re-entry course by rolling, which directed its off-center lifting force. The Mercury thrusters used a hydrogen peroxide monopropellant which turned to steam when forced through a tungsten screen, and the Gemini thrusters used hypergolic mono-methyl hydrazine fuel oxidized with nitrogen tetroxide.

The Gemini spacecraft was also equipped with a hypergolic Orbit Attitude and Maneuvering System, which made it the first manned spacecraft with translation as well as rotation capability. In-orbit attitude control was achieved by firing pairs of eight 25-pound-force (110 N) thrusters located around the circumference of its adapter module at the extreme aft end. Lateral translation control was provided by four 100-pound-force (440 N) thrusters around the circumference at the forward end of the adaptor module (close to the spacecraft's center of mass). Two forward-pointing 85-pound-force (380 N) thrusters at the same location, provided aft translation, and two 100-pound-force (440 N) thrusters located in the aft end of the adapter module provided forward thrust, which could be used to change the craft's orbit.

The Apollo Command Module had a set of twelve hypergolic thrusters for attitude control, and directional re-entry control similar to Gemini.

The Apollo Service Module and Lunar Module each had a set of sixteen R-4D hypergolic thrusters, grouped into external clusters of four, to provide both translation and attitude control. The clusters were located near the craft's centers of gravity, and were fired in pairs in opposite directions for attitude control.

A pair of translation thrusters are located at the rear of the Soyuz spacecraft; the counter-acting thrusters are similarly paired in the middle of the spacecraft (near the center of mass) pointing outwards and forward. These act in pairs to prevent the spacecraft from rotating. The thrusters for the lateral directions are mounted close to the center of mass of the spacecraft, in pairs as well.

Location of thrusters on spaceplanes

RCS thrusters on the nose of the Space Shuttle orbiter

The suborbital X-15 and a companion training aero-spacecraft, the NF-104 AST, both intended to travel to an altitude that rendered their aerodynamic control surfaces unusable, established a convention for locations for thrusters on winged vehicles not intended to dock in space; that is, those that only have attitude control thrusters. Those for pitch and yaw are located in the nose, forward of the cockpit, and replace a standard radar system. Those for roll are located at the wingtips. The X-20, which would have gone into orbit, continued this pattern.

Unlike these, the Space Shuttle Orbiter had many more thrusters, as it was required to carry out docking maneuvers in orbit. Shuttle thrusters were grouped in the nose of the vehicle and on each of the two aft Orbital Maneuvering System pods. No nozzles interrupted the heat shield on the underside of the craft, instead, the nose RCS nozzles which control positive pitch were mounted on the side of the vehicle, and were canted downward. The downward-facing negative pitch thrusters were located in the OMS pods mounted in the tail/afterbody.

Space station systems

The International Space Station uses electrically powered reaction control gyroscopes for primary attitude control, with RCS thruster systems as backup and augmentation systems.[1]

See also

References

External links

This article is issued from Wikipedia - version of the 5/6/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.