Puente Alto-El Volcan Railway

Puente Alto – El Volcan Railway Ferrocarril Militar de Puente Alto al Volcán
Rail bridge over the Río Colorado in the Cajon del Maipo
Map of the Maipo River
Line length:	60 km
Track gauge:	600 mm
Legend km 0 Puente Alto 8 La ObraLa Obra 12 El CaneloEl Canelo 16 El Manzano Río Colorado33°36′N 70°22′W / 33.600°N 70.367°W / 33.600; -70.367 24 San José de Maipo 34 El Melocotón 38 San Alfonso El Tinoco Tunnel33°44′N 70°17′W / 33.733°N 70.283°W / 33.733; -70.283 48 San Gabriel 53 El Romeral 60 El Volcán

Tinoco Tunnel

Interior of a wooden carriage at Melocoton Station

Old bridge

Puente Alto-El Volcan Railway is a small military railway line between Puente Alto and El Volcán in Chile. The railway has a narrow gauge of 600 mm (1 ft  11 ⁵⁄₈ in), and was constructed in 1906 under Chile's Ministry of Railways. As sections were completed, they were inaugurated on 1 March 1910 (from Puento Alto to El Canelo), in 1911 (from El Canelo to El Melocotón) and on 9 June 1914 (from El Melocotón to El Volcan). The railway was built at a cost of $2,335,630 and remained operational until 1985.^[1][2][3][4]

Planning

Objectives

The railway's main objective was not to unite Chile and Argentina (as claimed by Chile), but to monitor the border and prevent any attacks from Argentina on Chile.^[1] Originally, when the State Railway Company commissioned an engineer to study the area (who recommended the railway's construction), the idea was not taken seriously due to the lack of interest shown by the Chilean and Argentine governments.^[5] However, once the Army expressed the importance of this railway as a means of defence against a possible conflict, the Chilean government authorized its construction.

Its functions were to ensure practical training of military personnel and to provide strategic protection of the mountain passes.^[6] The military was responsible for the operation, management and repair of the railway.

Engineering Studies

Multiple studies were performed before the development of the railway:

1. In 1895, the Chilean engineer Alberto Lira Orrego studied the part of the road between Puente Alto and San Jose.
2. In 1899, there were reconnaissance missions covering the Maipo River to its source.^[3]
3. In 1901, the English engineer Josias Harding established that the route via the Maipo River was the most appropriate one
4. In 1902, the Chilean engineer Santiago Muñoz issued a report noting the enormous benefits that the railway would bring to the whole community, both in agriculture and trade (paper mills, coal and tissues).^[4]

Responsibilities

The State Railway Administration mainly supervised the desk work done before the construction (for example, making the inventory of material required for the construction and operation, regulations and cost estimates), though their decisions were subject to approval by many others (including the Ministry of Railways, the Army, the Ministry of Public Works and later the State Railway Company).^[6]

Operation

At first, the engines used to test the line were small German locomotives made by Koppel. These pulled flat bed and freight cars, narrow passenger cars made of wood, or sometimes a small buscarril.^[7]

As the train traveled on very steep terrain, the size of those German locomotives was sometimes insufficient for the climb. Therefore, in some cases, more than one engine was used; one at the front pulling the train and another at the back pushing the train. In other cases, just one small but powerful locomotive was used to push a shorter train up the slope.^[4]

Transporting copper concentrate, gypsum and limestone, livestock and agricultural products became more economical and safe by train. Railway passenger traffic from Cajon del Maipo and Santiago also started thanks those services, with the main intent being going on vacation in the Andean villages in the mountains.^[8]

It took 45 minutes for the 13.5 km journey from Puente Alto to El Canelo by steam train, 2 hours for the 35.8 km to El Melocotón, and 3½ hours for the 61.9 km to the terminus at El Volcán.^[9]

Closure

Since 1950 the use of the railway decreased as rail transport began to be replaced by higher tonnage road trucks, whose travel time and freight costs were lower.^[6] Many factors led to the suspension of the railway and the use of roads as the main form of transport: the closure of Llano del Maipo Railway in the late 1940s, the earthquake in Las Melosas in 1958 (which caused damage to infrastructure), severe storms in the mid-1960s and the end of mining activity in the Volcano in 1976.

In 1978, with the approval of the policy of self-financing State Railway, the railway ceased regular public use, maintaining only internal operations for investigation. Jung diesel locomotives were delivered a few months before the closure, but too late to show their benefits.^[6]

In 1985 the railway was closed, after seventy years of operation. The railway was dismantled by order of the Ministry of Public Works and carried out by the same men who drove the locomotives. The abrupt manner in which the procedures occurred remained in the memory of the inhabitants of the area.

Heritage status

Railroad Puente Alto (High Bridge) to El Volcan (the Volcano) and its associated infrastructure were declared a National Historic Landmark by the Ministry of Education Decree No. 432 in 1991.^[10] From that date, a series of restorations of the tracks and stations were performed. The 21.12.2002 agreement between the Chilean Army, the National Tourism Service (SERNATUR), the National History Museum, the Ministry of National Heritage and the National Monuments Council, was signed for the implementation of a restoration project on the grounds of the El Manzano station, in order to build a cultural center that would include the Museum of Military Railways.^[10] By the end of 2004, after the closure of Puente Alto Regiment, the steam locomotive "Panchita", together with some cars and trucks, was moved to El Melocotón station, where they are safely stored.

References