Palomar knot

Palomar knot
Category Hitch
Releasing Non-jamming
Typical use Fishing

The Palomar knot /ˈpæləmɑːr/ is a knot that is used for securing a fishing line to a fishing lure, snap or swivel.

Steps in tying a Palomar knot (free end is colored red). 1. Tie the loose overhand knot. 2. Pass the object through the remaining loop. 3. Start snug. 4. Finish snug (pull evenly on standing ends). 5. View of obverse side.

To tie the knot first double 8-12" of line into a loop and pass it through the eye of the hook, lure or swivel. Tie a very loose overhand knot using the doubled loop and the doubled section of line leading back to the fishing rod. Pass the object to be tied through the remaining loop of the overhand knot and slide the loop up onto the line just above the eye of the hook. Moisten the knot to lessen the friction and pull on the tag and standing ends evenly to snug the knot down. Trim the free end of the line to a length of about 3mm.

This knot is good for all kinds of light fishing lines, especially braided Dacron, and retains almost all of the original line strength, even with monofilaments. It also is nearly impossible (if tied correctly) to "pull out". It is equally effective with other fastening applications - such as a dog clip to a rope - provided the object being tied to can pass through the loop, and the line or rope is not too thick to pass through the object twice, and, with practice, it can be tied in the dark with cold hands.

See also


This article is issued from Wikipedia - version of the 1/29/2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.