London Underground 1992 Stock

1992 Stock

A train of 1992 stock leaving Theydon Bois station on the Central line
In service 1993 – present
Manufacturer BREL
(under ABB, now Bombardier Transportation)[1]
Built at Derby Carriage and Wagon Works, England[1]
Replaced British Rail Class 487
1962 Stock
Constructed 1991 - 1994[1]
Refurbishment Wabtec Rail UK
2006 (Waterloo & City trainsets only)[1]
Number built 680 cars
Formation 8 cars per trainset (Central Line)
4 cars per trainset (Waterloo & City)
Capacity 930 per trainset (Central Line)
444 per trainset (Waterloo & City)[1]
Line(s) served Central
Waterloo & City
Specifications
Car length 16.25 m (53 ft 4 in)
Width 2.62 m (8 ft 7 in)
Height 2.87 m (9 ft 5 in)
Maximum speed 100 km/h (62 mph)
Weight 20.5–22.5 tonnes (20.2–22.1 long tons; 22.6–24.8 short tons) (per car)
Traction system GTO thyristor
(ABB/Brush Traction)[2][1]
Electric system(s) 630V DC Fourth rail
Bogies H-frame (Siemens)
Seating 272 per trainset (Central Line)
136 per trainset (Waterloo & City)[1]
Stock type Deep-level tube
Notes
London Transport portal

The 1992 Tube Stock is the type of train used on the Central line and Waterloo & City line of the London Underground.

Construction

The 1992 Stock was built by BREL (under ABB, later Adtranz and now Bombardier Transportation) for the Central line as the result of the extensive testing of the three 1986 tube stock prototype trains.[3] Even so, the introduction of this stock was far from trouble-free and there were many technical teething problems.

Eighty-five trains were ordered from BREL, each formed of four two-car units (two units have driving cabs, the others are fitted with shunting controls).[3] Upon entering service in April 1993, the new units gradually replaced the previous 1962 tube stock, which was finally withdrawn two years later. The trains were manufactured at the former BREL Carriage Works in Derby (Now the Bombardier Derby Carriage and Wagon Works).

The propulsion for the trains was manufactured by a consortium of ABB and Brush Traction,[2] and was one of the first examples of microprocessor controlled traction featuring a fibre-optic network to connect the different control units. The DC traction motors of LT130 type have separately-excited fields and are controlled via GTO (Gate turn-off) thyristors.[2]

A Wheel Slide Protection (WSP) system was retrofitted due to the fleet suffering an epidemic problem of wheel flats. This was largely due to an excessive number of emergency brake applications caused during the ATO/ATP testing phases.

A fault in a train of this type led to the Chancery Lane derailment on 25 January 2003. The whole fleet had to be taken out of service for several months, which required the suspension of all services on the Central and Waterloo & City lines, to permit faulty bolts to be replaced.

The 1992 stock's design is reminiscent of the 1986 prototypes. The new 2009 stock trains, built by Bombardier Transport for the Victoria line, are more like the 1992 stock in shape and design than the 1995/1996 stock.

Due to ongoing problems regarding excessive carbon brush wear, the replacement of the DC motors was considered, but decided against. However the 1992 stock may still receive AC motors in the future.

Waterloo & City line sets

Waterloo & City line train at Bank

After the initial construction run, an additional ten two-car units were built for British Rail for the Waterloo & City line, which until 1994 was part of the national railway network, and became their Class 482. When this line passed to London Underground at the start of the process to privatise British Rail on 1 April 1994, these units also passed to London Underground.[3] The vehicles are essentially identical to those used on the Central line; the main difference being that trip-cocks are used for protection instead of ATO/ATP.

Transport for London and Metronet closed the Waterloo & City line for five months from April to September 2006 to allow major upgrade work on the tunnels and rolling stock. The line's limited access meant that this was first time that the units had been brought above ground since their introduction 12 years earlier. The refurbishment of the trains saw them painted in the London Underground white, red and blue livery having operated in Network SouthEast colours since the stock's introduction.

Operation

The 1992 stock is one of the few stock types on the London underground to feature both ATO (Automatic Train Operation) and ATP (Automatic Train Protection) which effectively allow the trains to drive themselves. The ATO is responsible for operating the train whilst the ATP detects electronic codes in the track and feeds them to the cab displaying the target speed limits. This functionality is configured via a master switch in the driver's cab which can be set to one of three positions: Automatic, Coded Manual and Restricted Manual.

In Automatic Mode the ATO and ATP are both fully operational. The driver is only required to open and close the doors and press both "Start" buttons when the train is ready to depart. The ATO will then control the train to the desired target speed, whilst the ATP is ready to apply the emergency brakes if the Maximum Safe Speed is exceeded.

In Coded Manual Mode, the ATO is disabled and the driver operates the train manually, however the ATP is still detecting the codes in the track and restricting the driver's actions. The speedometer on 1992 stock is the horizontal strip design covering two speeds: the Current Speed in green, indicating the speed at which the train is actually travelling, and the Target Speed indicating the speed at which the train should be travelling. Although the target speed is always active whilst running in Automatic or Coded Manual mode, whilst in coded manual mode, changes in the target speed are indicated with an upwards or downwards tone depending on whether the target speed is increasing or decreasing. Should the driver exceed the target speed, an alarm sounds and the emergency brakes are automatically applied until the train is within the target speed, the alarm then stops.

In Restricted Manual Mode, the train cannot exceed 18 km/h (11 mph) and the motors automatically cut out at 16 km/h (10 mph). The ATO and ATP are both disabled and the driver operates the train entirely by sight and according to the signals. This mode is used when there has been an ATP failure or a signal failure or in a depot where ATP is not used, e.g. West Ruislip and Hainault depots. On the main line, driving in ATO is the same for a train driver as driving through a section where signals have failed.

Announcer system

The 1992 Stock was the first of its type on the Underground to have a DVA (Digital Voice Announcer) from new. Until mid-2003, the DVA was voiced by then BBC journalist and presenter Janet Mayo, subsequently nicknamed 'Sonia', as some drivers thought the repetitiveness of the announcements 'gets on ya nerves'.[4]

The original format of the announcements were as follows:

Since mid-2003, voice artist Emma Clarke has provided recordings for the 1992 Stock DVA, which were again revised in 2006. Emma continues to voice the line, despite London Underground allegedly 'sacking' her after an article by the Daily Mail was published in 2007. The article took her words from an interview out of context; saying that she "hated the tube," when in actual fact, she just said that she would not like to be in a tube carriage voiced by herself for self-conscious reasons.[5]

The present format of the announcements is as follows:

2011 refresh

Interior of 1992 Stock, having undergone the 2011 refresh

The 1992 Stock has had a refresh of both the interior and exterior. Some of the noticeable changes include new a new seat moquette, improved lighting and improvements to the window frames. The front of the driving cabs are also being renewed. This includes repairing water ingress and replacing the complex number of parts with a much simpler design, saving costs on future work. The new-style front end can be easily identified by the red panelling instead of the original grey. The refresh comes after nearly twenty years of continuous service on the Central line.

The Waterloo & City line's units also received the new moquette, but did not receive the new window frames or cab ends[6]

Future replacement

In October 2014, it was confirmed that the 1992 stock will be replaced by new semi-articulated trains currently known as the 'New Tube for London'. The stock will be used on the Bakerloo, Piccadilly, Central and Waterloo & City lines, and is due to enter service during the 2020s.[7]

References

  1. 1 2 3 4 5 6 7 Neil, Graham. "London Underground Rolling Stock Information Sheet" (PDF). WhatDoTheyKnow. Retrieved 17 April 2016.
  2. 1 2 3 "A-Series EMU Car Review, Paper tabled to WA Parliament" (PDF). Parliament of Western Australia.
  3. 1 2 3 "1992". Transport for London. Retrieved 13 August 2012.
  4. ↑ "1992 tube stock: Sonia". SQUAREWHEELS.org.uk. Retrieved 2014-07-13.
  5. ↑ http://news.bbc.co.uk/1/hi/7113545.stm
  6. ↑ https://www.whatdotheyknow.com/request/247718/response/615841/attach/6/RS%20Info%20Sheets%204%20Edition.pdf
  7. ↑ "New Tube for London". Transport for London. October 2014. Retrieved 12 October 2014.
Wikimedia Commons has media related to London Underground 1992 Stock.
This article is issued from Wikipedia - version of the 10/22/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.