Integral windup

Main article: PID controller

Integral windup, also known as integrator windup^[1] or reset windup,^[2] refers to the situation in a PID feedback controller where a large change in setpoint occurs (say a positive change) and the integral terms accumulates a significant error during the rise (windup), thus overshooting and continuing to increase as this accumulated error is unwound (offset by errors in the other direction). The specific problem is the excess overshooting.

Solutions

This problem can be addressed by:

Initialising the controller integral to a desired value, for instante this before the problem
Increasing the setpoint in a suitable ramp
Disabling the integral function until the to-be-controlled process variable (PV) has entered the controllable region
Preventing the integral term from accumulating above or below pre-determined bounds
Back-calculating the integral term to constrain the process output within feasible bounds.^[3]

Occurrence

Integral windup particularly occurs as a limitation of physical systems, compared with ideal systems, due to the ideal output being physically impossible (process saturation: the output of the process being limited at the top or bottom of its scale, making the error constant). For example, the position of a valve cannot be any more open than fully open and also cannot be closed any more than fully closed. In this case anti-windup can actually involve the integrator being turned off for periods of time until the response falls back into an acceptable range.

This usually occurs when the controller's output can no longer affect the controlled variable, or if the controller is part of a selection scheme and it is selected right.

Integral windup was more of a problem in analog controllers. Within modern Distributed Control Systems and Programmable Logic Controllers, it is much easier to prevent integral windup by either limiting the controller output, or by using external reset feedback, which is a means of feeding back the selected output to the integral circuit of all controllers in the selection scheme so that a closed loop is maintained.

References

↑ "Microchip Application Note AN532: Servo Control of a DC Motor" (PDF). Microchip Technology, Inc. 1997. p. 4. Retrieved 2014-01-07.
↑ M. Tham. "Discretised PID Controllers". Retrieved 2014-01-07.
↑ Cooper, Douglas. "Integral (Reset) Windup, Jacketing Logic and the Velocity PI Form". Retrieved 2014-02-18.

This article is issued from Wikipedia - version of the 11/28/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.