Heart Mountain (Wyoming)

For other mountains with the same name, see Heart Mountain (disambiguation).
Heart Mountain
Highest point
Elevation 8,123 ft (2,476 m)
Prominence 2,163 ft (659 m)
Coordinates 44°40′0″N 109°7′5″W / 44.66667°N 109.11806°W / 44.66667; -109.11806
Geography
Location Park County, Wyoming, U.S.
Topo map USGS Heart Mountain
Geology
Mountain type Limestone

Heart Mountain is an 8,123-foot (2,476 m) klippe just north of Cody in the U.S. state of Wyoming, rising from the floor of the Bighorn Basin. The mountain is composed of limestone and dolomite of Ordovician through Mississippian age (about 500 to 350 million years old), but it rests on the Willwood Formation, rocks that are about 55 million years old—rock on the summit of Heart Mountain is thus almost 300 million years older than the rocks at the base.[1] For over one hundred years, geologists have tried to understand how these older rocks came to rest on much younger strata.

The carbonate rocks that form Heart Mountain were deposited on a basement of ancient (more than 2.5 billion years old) granite when the area was covered by a large shallow tropical sea. Up until 50 million years ago, these rocks lay about 25 miles (40 kilometers) to the northwest, where the eastern Absaroka Range now stands.

Satellite photo of Heart Mountain and the surrounding area

Between 75 and 50 million years ago, a period of mountain-building called the Laramide Orogeny caused uplift of the Beartooth Range and subsidence of the Bighorn and Absaroka Basins. Just south of the Beartooth Range, this orogeny uplifted an elongate, somewhat lower plateau which sloped gently to the southeast toward the Bighorn Basin and to the south toward the Absaroka Basin. Immediately following this period of mountain-building, volcanic eruptions began to form the now extinct volcanoes of the Absaroka Range that lie to the south of the Beartooths and extend into Yellowstone National Park. Between 50 and 48 million years ago a sheet of rock about 500 square miles (1,300 square kilometers) in area detached from the plateau south of the Beartooths and slid tens of kilometers to the southeast and south into the Bighorn and Absaroka Basins.[1] This sheet, consisting of Ordovician through Mississippian carbonate rocks and overlying Absaroka volcanic rocks, was probably originally about 4–5 kilometers thick. Although the slope was less than 2 degrees, the front of the landslide traveled at least 25 miles (40 km) and the slide mass ended up covering over 1,300 square miles (>3,400 km²). This is by far the largest rockslide known on land on the surface of the earth and is comparable in scale to some of the largest known submarine landslides.[2]

Many models have been proposed to explain what caused this huge slab of rocks to start sliding and what allowed it to slide so far on such a low slope, fragmenting, thinning and extending as it went. Most geologists who have worked in the area agree that Absaroka volcanism played a role in the sliding and many suggest that a major volcanic or steam explosion initiated movement. Another model involves injection of numerous igneous dikes with the resulting heating of water within pores in rocks causing an increase in pressure which initiated sliding. Some geologists have suggested that hot pressurized water (hydrothermal fluids), derived from a volcano which sat north of Cooke City, Montana, effectively lubricated the sliding surface. Another possibility is that once the slide was moving, friction heated the limestone along the sliding surface, creating pseudotachylite,[3] which then further broke down to calcium oxide and carbon dioxide gas (or supercritical fluid).[2] The gas supported the slide in the way that air pressure supports a hovercraft, allowing the slide to move easily down the very low slope. When the rockslide stopped, the carbon dioxide cooled and recombined with calcium oxide to form the cement-like carbonate rock now found in the fault zone. The consensus favors catastrophic sliding and calculations suggest that the front of the sliding mass may have advanced at a speed of over 100 miles/hour (160 km/h), meaning that the mountain traveled to its present location in approximately 30 minutes.[4]

In the 48 million years since the slide occurred, erosion has removed most of the portion of the slide sheet which moved out into the Bighorn Basin, leaving just one big block of carbonate rocks—Heart Mountain.[3] Farther south, a large block of carbonate rock forms Sheep Mountain, which lies just south of the road that goes from Cody into Yellowstone Park. Some of the best views of the sliding surface, called the Heart Mountain fault, can be found along the Chief Joseph Highway (Wyoming Highway 296). The fault is particularly well exposed in Cathedral Cliffs, where it appears as a remarkably straight and nearly horizontal line just above a 2–3-meter-high cliff.

The nearby Heart Mountain War Relocation Center, where a number of Japanese Americans were interned during World War II, was named after the peak.

See also

References

  1. 1 2 "Heart Mountain, Wyoming". NASA Earth Observatory. Retrieved 2006-05-17.
  2. 1 2 "Giant rock slab slid on hot lube". New Scientist. 7 May 2005. p. 19. Retrieved 2006-05-17.
  3. 1 2 Alden, Andrew. "A Superfault Superlandslide". About.com. Retrieved 2010-11-12.
  4. Binns, Corey (19 May 2006). "Land Speed Record: Mountain Moves 62 Miles in 30 Minutes". LiveScience. Retrieved 2006-05-19.

 This article incorporates public domain material from websites or documents of the National Aeronautics and Space Administration.

This article is issued from Wikipedia - version of the 9/9/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.