Head in pillow (metallurgy)

In the assembly of integrated circuit packages to printed circuit boards, a head in pillow defect is a failure of the soldering process. For example, in the case of a ball grid array package, the pre-desposited solder ball on the package and the solder paste applied to the circuit board may both melt, but the melted solder does not join. A cross-section through the failed joint shows a distinct boundary between the solder ball on the part and the solder paste on the circuit board, rather like a section through a head resting on a pillow.[1]

The defect can be caused by surface oxidation or poor wetting of the solder, or by distortion of the integrated circuit package or circuit board by the heat of the soldering process. This is particularly a concern when using lead-free solder, which requires higher processing temperature.

Since the warping of the circuit board or integrated circuit may disappear when the board cools, an intermittent fault may be created. Diagnosis of head-in-pillow defects may require use of X-rays or EOTPR(Electro Optical Terahertz Pulse Reflectometry), since the solder joints are hidden between the integrated circuit package and the printed circuit board.

References

  1. Addressing the Challenge of Head-in-Pillow Defects in Electronics Assembly
This article is issued from Wikipedia - version of the 9/5/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.