Cargo hook (helicopter)

A cargo hook is a device suspended below a helicopter and allows the transport of external loads during flight. Common terms for this operation include slingwork, underslung loads, external loadwork, and external load operations.

Hook types

Primary hooks

A Eurocopter AS350 helicopter with a belly hook installed.
A Eurocopter AS350 helicopter with a belly hook installed. This configuration is called a swing or suspension system mount because the actual cargo hook drops down from inside a swing frame that is suspended from the fuselage by four cables.

Primary, or "belly", hooks are designed to mount directly to the airframe belly, i.e. underside, of a helicopter. Because they are attached to the fuselage, or "skin," of the aircraft, belly hooks are regulated by the various worldwide aviation regulatory agencies. In the United States, belly hooks are governed under Federal Aviation Administration (FAA) FAR Part 133.[1] Belly hooks are designed, manufactured, and approved for use on specific aircraft models. Belly hooks that have been certified by the FAA receive a Supplemental Type Certificate (STC)[2] that describes the aircraft models that are authorized to use the hook for external load operations. For example, a belly hook approved for use by the FAA on a Eurocopter AS350 could not be used on a Bell 407 helicopter unless covered by the STC.

For small to mid-size utility helicopters performing external load work, belly hooks are typically mounted to the fuselage using either a sling or a suspension configuration. The sling mount uses a single attachment point, whereas a suspension system uses four attachment points. Since suspension systems transfer the weight of the cargo load across a larger swath of the aircraft, they can carry heavier loads than sling mounts.

Remote hooks

An R44 lifting Christmas trees
A Robinson R44 Raven II helicopter using a remote hook to lift Christmas trees. The remote hook is suspended from the belly hook with a long line.

Remote hooks are suspended beneath the belly hook by a long line, swivel, or other device. Because they are not attached directly to the airframe, they do not require aircraft-specific certification and can be used on a wide variety of helicopter models.

Technical details

Parts of a cargo hook

Key components of a cargo hook include the load beam, the keeper, and the attach point. The load beam is the solid piece of metal at the bottom of a cargo hook that supports the load. Usually it has a curved, narrow end which is used to load a ring, rope, or net onto the hook. The keeper is the locking, spring-operated mechanism that keeps the load from sliding off the load beam during transport. The attach point attaches the hook to the belly of the helicopter, swing system, or longline.

Helicopters & load capacities

The following table includes a list of helicopter models that are designed to carry underslung loads.[3] Cargo capacities provided reflect the airframe manufacturer's specifications; when put into practice the actual maximum load capacities may be less, depending on the rating of the cargo hook equipment. For example, if a helicopter model is rated by the manufacturer as having a maximum cargo sling load capacity of 4,000 LB, but the cargo hook equipment is only rated for 3,000 LB, then the pilot can only carry loads weighing 3,000 LB or less.

Manufacturer Model Slingload Cargo Capacity
Aerospatiale Alouette II SE 3130, SA 313 2,500 LB
Aerospatiale Allouette III SA 316-319 1,650 LB
Aerospatiale/Eurocopter AS 350/355 3,086 LB on swing suspension 2,557 LB mounted directly to airframe
Aerospatiale/Westland SA 330 Puma 7,055 LB
Agusta A109 1,500 LB
Bell 204/UH-1 4,000 LB
Bell 205/UH-1H 4,000 LB
Bell 206 Jet Ranger/OH-58 1,500 LB
Bell 206 Long Ranger 2,000 LB
Bell 212 4,000 LB
Bell 412 4,000 LB
Bell-Boeing V-22 Osprey 15,000 LB
Boeing/Vertol CH-47 28,000 LB
Hindustan Aeronautics Ltd DHRUVS ALH 3,300 LB
MD Helicopters 369D/E, 500N 2,000 LB
MIL MI-6 17,650 LB
MIL M-8/MI-17 HIP C-K 6,614 LB
MIL MI-10/MI-10K Harke 36,600 LB
Sikorsky S-64E/F Sky Crane 20,000 LB
Sikorsky S-70/UH-60 Black Hawk/SH-60 Seahawk 9,000 LB

Common usage

Utility helicopter operators perform a wide variety of external load work that varies region to region and season to season. Some of the most common external load operations include:

See also

References

  1. ↑ FAA FAR Part 133 "FAR Part 133" Check |url= value (help). FAA. Retrieved 29 December 2011.
  2. ↑ FAA Supplemental Type Certificates (STC)
  3. ↑ McGowen, Stanley S. (2005). Helicopters: An Illustrated History of their Impact, pp 226-296. Santa Barbara: ABC-CLIO, Inc.
  4. ↑ MacDonald, J., Rossnagle, W., & Higgins, L. (2009). Handbook of Rigging: For Construction and Industrial Operations (5th Edition — pp. 543-553). New York: McGraw-Hill Professional
  5. ↑ Homeland Security Committee Approves Bill to Regulate Fertilizer June 15, 2006, ROTORNEWS
  6. ↑ "Helicopter Logging (heli-logging)" FORESTRY.COM, October 22, 2008
  7. ↑ "Tree Culturing & Harvesting," Pacific Northwest Christmas Tree Association
  8. ↑ Verdecchio, Tom, " " TRANSMISSION & DISTRIBUTION, November 1, 2004 Helicopter Live Work Requires a Safe Platform
  9. ↑ "Helicopter Pilot Jobs: Position Description". AVJobs. Archived from the original on 2 May 2012. Retrieved 18 May 2012.
  10. ↑ "Helicopter External Load Equipment," Rotor & Wing Maintenance Archived November 29, 2011, at the Wayback Machine.
  11. ↑ Heppler, Johnny, "Marijuana Grow Destroyed and 38-Arrested by Washington County Area Drug Task Force," July 17, 2011, KCSG Television
  12. ↑ "Aerial Side-Trimmer Saw". Haverfield Aviation. Retrieved 18 May 2012.
This article is issued from Wikipedia - version of the 11/18/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.