Boot (torture)

This article is about the boot as a torture device. For other uses, see Boot (disambiguation).
leg screw

The term boot refers to a family of instruments of torture and interrogation variously designed to cause crushing injuries to the foot and/or leg. The boot has taken many forms in various places and times. Common varieties include the Spanish boot (sometimes referred to as "scarpines") and the Malay boot. One type was made of four pieces of narrow wooden board nailed together. The boards were measured to fit the victim's leg. Once the leg was enclosed, wedges would be hammered between the boards, creating pressure. The pressure would be increased until the victim confessed or lost consciousness. Newer variants have included iron vises—sometimes armed with spikes—that squeezed feet and metal frames employed red-hot.

Spanish boot

Spanish gaiter

The Spanish boot was an iron casing for the leg and foot. Wood or iron wedges were hammered in between the casing and the victim's flesh. A similar device, commonly referred to as a shin crusher, squeezed the calf between two curved iron plates, studded with spikes, teeth, and knobs, to fracture the tibia and fibula.[1]

Primitive forerunners of the archetype can be found dating back as far as a thousand years. The first Scottish effort, also referred to as a buskin, made use of a vaguely boot-shaped rawhide garment that was soaked with water, drawn over the foot and lower leg, and bound in place with cords. The contraption was slowly heated over a gentle fire, drastically contracting the rawhide and squeezing the foot until the bones were dislocated, though there would not have been sufficient pressure actually to crush the bones of the foot. A more progressive variant, found in both the British Isles and France, consisted of a trio of upright wooden boards that splinted around and between the feet and were tied in place by cords. Wedges were hammered between the boards and the feet to dislocate and crush the bones. A prototype hailing from Autun, France, consisted of high boots of spongy, porous leather that were drawn over the feet and legs. Boiling water was poured over the boots, eventually soaking through the leather and eating the flesh away from the entrapped limbs. Lastly, oversized boots of iron or copper (often soldered in place on the floor) received the prisoner's bare feet as he lay helplessly bound and gagged in a chair. The boots were slowly filled with boiling water or oil, or even molten lead, to consume the feet and legs. One variant—applied in Ireland to the martyr Dermot O'Hurley—consisted of lightweight metal boots that were filled with cool water and heated with the feet inside over a fire until the water boiled aggressively.

Foot press

A similar implement, the foot press or foot screw, consisted of a pair of horizontal iron plates slowly tightened around the bare foot by means of a crank mechanism to crush the bones. Although it was quite standard to line the lower plate with ribs to prevent the foot from popping out of the grip of the instrument as it became sweatier, a crueler variant of this devicetypically encountered in Nuremberg, Germanylined the upper plate with hundreds of sharp spikes. A version from Venice, sometimes called the foot screw or toe breaker, connected the crank mechanism to a drill that slowly mutilated the foot by boring a hole through the center of the instep as the press was tightened. The instrument was of sufficient power and cruelty to pulverize the tiniest of toe bones.[2]

Medieval boots were built according to a wide array of architectures. One commonly encountered boot consisted fundamentally of a pair of parallel boards that splinted the foot from heel to toes and were connected by a screw mechanism. Turning the screw drives the boards together and inflicts untold lateral pressure on the metatarsal heads, causing agony. This is the type of boot commonly associated with the torture of Esmeralda in Victor Hugo's Hunchback of Notre-Dame. The cruelty of the torture could be increased by spacing the toes apart with stiff wooden pegs. Various extensions of the instrument were designed to crush the ankle, calf, and/or knee in addition to its primary target, the instep. The toes often protruded from the front of the boot, facilitating the infliction of additional tortures, such as forcibly tearing the nails from the toes with red-hot iron pincers.

In their The Big Book of Pain,[3] Donnelly and Diehl present an ingeniously designed boot that is very technologically sophisticated. The carefully contoured instrument is patterned after a comfortable open-backed clogexcept that its toe box offers not soft leather but a layer of iron spikes, burrs, and teeth carefully designed to attack the toes from every direction. The naked foot rests upon an iron skate that is slowly driven forward by a stout heel plate operated by a large crank handle. Steadily increasing pressure forces the toes and metatarsals against the metal protrusions, shredding the flesh of the toes and pulverizing their bones. Continued tightening of the screw at the heel could generate enough pressure to shatter the bones of the instep.

References in literature and the cinema

References

  1. McCall, Andrew (1979). The Medieval Underworld. London: Hamish Hamilton. ISBN 978-0-7509-3727-6. OCLC 56009769.
  2. This family of torture devices is not widely recorded but is described by Richard Sair, deriving largely from the Earl of Shrewsbury's traveling exhibit of torture devices from Nuremberg Castle. Sair, Richard (1944). Hirsch, Arnold, ed. The Book of Torture and Executions: A Historical Analysis of the Science of Brutality. Toronto: Golden Books of America. OCLC 48994719.
  3. Donnelly, Mark; Diehl, Daniel (2008). The Big Book of Pain: Torture and Punishment Through History. Stroud, U.K.: History Press. ISBN 9780750945837. OCLC 181926734.
This article is issued from Wikipedia - version of the 11/20/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.