Asphalt roll roofing

Roofers applying commercial grade "torch-applied" modified bitumen roll roofing.

Asphalt roll roofing or membrane is a roofing material commonly used for buildings that feature a low sloped roof pitch in North America. The material is based on the same materials used in asphalt shingles; an organic felt or fiberglass mat, saturated with asphalt, and faced with granular stone aggregate.[1]


Overview

Roll roofing is usually restricted to a lightweight mat compared to shingles, as it must be rolled for shipment. Rolls are typically 36 inches (91 cm) by 33 feet (10 m) in size.[2] Due to its light weight compared to shingles, roll roofing is regarded as an inexpensive, temporary material. Its wide width makes it vulnerable to temperature-induced shrinkage and tearing as it expands and contracts.

Other names for this material are "asphalt prepared roofing, asphaltic felt, cold-process roofing, prepared roofing, rolled roofing, rolled strip roofing, roofing felt, sanded bituminous felt, saturated felt, self-finished roofing felt."[3]

Roll roofing is normally applied parallel to the eaves from the bottom of the roof upwards, lapping each new roll in the same manner as shingles. Its use is restricted to roofs with a pitch of less than 2:12. To avoid penetrating the exposed membrane with nails, adhesive or "lap cement" must be used at the bottom edge to keep it from being lifted by the wind. The upper edge of the roll is nailed and covered by the next roll.[4]

Uses

This roll roofing on the roof was applied vertically and is in very poor condition.
Horizontally applied roll roofing on a ruined log cabin. Image: American Historic Building Survey

The main uses are:

Types

Several variations of bitumen roofing felt are available.

Fibre content:

Bitumen:

Underside:

Topping:

Double coverage:

Application methods

References

  1. "What is roll roofing?". All About Roofing. Asphalt Roofing Manufacturers Association. 2009. Retrieved 2009-06-18.
  2. "Mineral Surfaced Roll". Owens Corning Roofing. 2009. Retrieved 2009-06-18.
  3. "cold-process roofing." McGraw-Hill Dictionary of Architecture and Construction. 2003. The McGraw-Hill Companies, Inc. 20 Dec. 2013 http://encyclopedia2.thefreedictionary.com/cold-process+roofing
  4. "2" and 4" Selvedged Mineral Surface Roll Roofing Application Instructions" (PDF). Owens Corning Roofing and Asphalt, Inc. 2008. Retrieved 2009-06-18.
  5. DeCristoforo, R. J.. Housebuilding: a-do-it-yourself guide. Rev. & updated ed. New York: Sterling Pub., 2007. 295. Print.

See also

http://wiki.diyfaq.org.uk/index.php?title=Roofing_felt


This article is issued from Wikipedia - version of the 11/5/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.